To latest comment

[PMD401]What is "Index Mode No.6 = zMODE"?

Firist, i sending command "X1N4" for set to index find mode.

And then, I send command "X1N" for check about index mode

I thought about In general case, it would return the string "X1N:4,1".

but controller has returned string "X1N:6,1"

What is "Index mode 6"? this mode is no contents in the manual.

I checked about the meaning of "index mode 6" using sending "X1N?"command.
The result returned "X1N:6,1, zMode".

what is 'zMode'?


NOTE
Controller : PMD401
Motor : LL06A0-101M1G1E2

YoungBu Noh Report inappropriate content

Comments

  • Dear YoungBu Noh,
    The driver reports stop + reset position at index by value 2 + 4 = 6. You are right, this is not described in the manual. It would be more consistent to report N:4 or allow N6 as command.
    Best regards,
    Anders
    Anders

Add your comment or create a new post

Your name and post can be seen by everyone.Your e-mail will never be shown publicly.